DESCRIPTION
The Production Noise Logging Tool uses a piezzoelectric crystal to detect downhole audio frequencies and amplitude variations due to fluid and gas movement. The audio sound from the tool through a surface module allows the operator to monitor well conditions.
The Production Noise Tool is normally run in combination with the Casing Collar Locator (CCL) and a temperature sensor. A typical operation is to record the temperature log with a casing collar locator during descent and the noise log incrementally during ascent.
| Amplitude Noise variation | 1/10 mV - 10V |
| dB Range | 50 - 130 dB |
| Sensor type | Piezo-electric crystal |
| Recorded logging mode | Stationary |
| Tool Outer Diameter | 1 3/8" |
| Tool Length | 30" |
| Frequency Response | 100 Hz -10 kHz |
APPLICATIONS
- Locate Fluid or Gas entry points
- Channel identification
- Locate downhole mechanical problems
- Identify fluid contacts in well bore
- Identify active perforations
If you are interested in this service, please fill out our Service Request Form, so that we can get back to you promptly.
